Problem |
| Action | |||
|
|
|
| ||
| • Plug the power cord into a live electrical outlet. | ||||
| • Check the fuse or reset the circuit breaker. | ||||
|
|
| |||
| • | Close the door and press |
| Start/Pause to start the washing | |
|
| ||||
|
| machine. For your safety, the washing machine will not | |||
|
| tumble or spin unless the door is closed. | |||
| • Before the washing machine starts to fill, it will make a series | ||||
|
| of clicking noises to check the door lock and does a quick | |||
Stops. |
| drain. | |||
• There may be a pause or soak period in the cycle. Wait briefly | |||||
| |||||
|
| and the washing machine may start. | |||
| • Make sure the mesh filter of the water supply hose at the | ||||
|
| water taps is not clogged. Periodically clean the mesh filter. | |||
| • If the washing machine is not supplied with sufficient power, | ||||
|
| the washing machine temporarily will not drain or spin. As | |||
|
| soon as the washing machine regains sufficient power, it will | |||
|
| operate normally. | |||
|
|
|
| ||
| • Fully open both taps. | ||||
| • Make sure the temperature selection is correct. | ||||
| • Make sure the hoses are connected to the correct taps. Flush | ||||
|
| water lines. | |||
| • Make sure the water heater is set to supply a minimum 120 | ||||
|
| °F (49 °C) hot water at the tap. Also, check the water heater | |||
|
| capacity and recovery rate. | |||
Fills with the wrong | • Disconnect the hoses and clean the mesh filter. The mesh | ||||
| filter may be clogged. | ||||
water temperature. |
| ||||
• While the washing machine fills, the water temperature may | |||||
| |||||
|
| change as the automatic temperature control feature checks | |||
|
| incoming water temperature. This is normal. | |||
| • While the washing machine fills, you may notice just hot and/ | ||||
|
| or just cold water going through the dispenser when cold or | |||
|
| warm temperatures are selected. This is a normal function | |||
|
| of the automatic temperature control feature as the washing | |||
|
| machine determines the water temperature. | |||
|
|
|
| ||
| • Use the High or Extra High spin speed. | ||||
Load is wet at the | • Use high efficiency (HE) detergent to reduce oversudsing. | ||||
• Load is too small. Small loads (one or two items) may become | |||||
end of a cycle. | |||||
| unbalanced and not spin completely. | ||||
|
| ||||
| • Make sure the drain hose is not kinked or clogged. | ||||
|
|
|
|
|
Troubleshooting
English 49