To remove the faceplate:
1Loosen the two captive screws securing the faceplate to the chassis.
2Pull the faceplate away from the system.
ERROR
LANplex 2500
Power | Run | Processor Power | Fan | Temp | Config |
PCMCIA
Inserted
Captive screw
Captive screw | Faceplate |
Read if replacing a module
You can replace a module while the system is powered on. Replacing the module requires that you remove the attached cables from the module’s ports prior to installing the new module.
To replace a module:
1Disconnect the cables from the module’s ports.
2Loosen the two captive screws securing the module to the chassis.
3Pull the module out of the chassis.
The following figures show termination of unterminated BNC ports using either a Y connector or a
| ERROR | PCMCIA |
LANplex 2500 Power Run | Processor Power Fan Temp Config | Inserted |
| Green = Active | Port Status |
| Yellow = Error | |
| Board | Active |
| Error | Error |
|
|
|
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Unterminated |
|
|
|
|
|
|
|
| Port Status |
Board |
|
|
|
|
|
|
|
| Active |
Error |
|
|
|
|
|
|
|
| Error |
1 | 2 | 3 | 4 |
| 5 |
| 6 | 7 | 8 |
Captive screw
Y terminator | Unterminated |
| |
BNC terminating plug | option module |