Placing Units On Top of Each Other 25
Figure 7 Fitting a bracket for rack mounting
3Insert the three screws and tighten w ith a suitable screwd river.
You must use the screws supplied with the mounting brackets. Damage
caused to the unit by using incorrec t screws invalidates your warranty.
4Repeat steps 2 and 3 for the other side of the Switch.
5Insert the Switch into the 19-inch rack and secure with suitable screws
(not provided). Ensure that ventilation holes are not obstructed.
6Connect network cabling.
Placing Units On Top of Each Other
If the Switch units are free-standing, up to four units can be placed one
on top of the other. If you are mixing a variety of SuperStack II Switch and
Hub units, the smaller units must be positioned at the top.
If you are placing Switch units one on t op of the other, you must use the
self-adhesive rubber pads supplied. Apply t he pads to the underside of
each Switch, sticking one in the marked area at each corner. Place the
Switch units on top of each other, ensuring that the pad s of the upper
unit line up with the recesses of the lower unit.
16980ua.bk Page 25 Friday, April 30, 1999 9:03 AM