30 CHAPTER 2: INSTALLING THE SWITCH
The Power-up Sequence
The following sections describe how to get your Switch 4400
powered-up and ready for operation.
Powering-up the
Switch 4400
Use the following sequence of steps to power-up the Switch.
1Plug the power cord into the power socket at the rear of the Switch.
2Plug the other end of the power cord into your power outlet.
The Switch powers-up and runs through its Power On Self Test (POST),
which takes approximately 10 seconds.
Checking for Correct
Operation of LEDs
During the Power On Self Test, all ports on the Switch are disabled and
the LEDs light in a set sequence.
When the POST has completed, check the Power/Self Test LED to make
sure that your Switch is operating correctly. Table6 shows possible colors
for the LED.
Tabl e 6 Power/Self Test LED colors
If there is evidence of a problem, see “Solving Problems Indicated by
LEDs” on page 58.
Connecting a
Redundant Power
System
You can connect a SuperStack 3 Advanced Redundant Power System
(3C16071B) to the Switch. This unit, which is also known as an RPS, is
designed to maintain the power to your Switch if a power supply failure
occurs.
For normal redundancy, the Switch 4400, Switch 4400 SE, and
Switch 4400 FX require one Type 2A Power Module (3C16074A). For full
redundancy, the Switch 4400, Switch 4400 SE, and Switch4400 FX
require two type 2A Power Modules combined using a Type 2 Y-Cable.
The Switch 4400 PWR (3C17205) requires one Type 3 Power Module
(3C16075) for normal redundancy and two Type 3 Power Modules for full
redundancy.
Color State
Green The Switch is powered-up and operating normally.
Yellow The Switch has failed its Power On Self Test.
Off The Switch is not receiving power.
DUA1720-3AAA07.book Page 30 Wednesday, March 17, 2004 1:14 PM