3Com MD55 CONTROLS AT A GLANCE, Step, Step, Step, Step, Medium, Regular, Delicate, Normal –, Extra Low, Time Dry –, Dry Temp –, Very Dry –, Damp Dry –, Sensor Dry –

CONTROLS AT A GLANCE

Step 1

Sensor Dry – automatically senses the moisture in the load and shuts the dryer off when the selected dryness level (very dry to damp dry) is reached.This cycle is recommended for the majority of loads including delicates, wrinkle free and cotton/sturdy items like towels, bedding and jeans.

Or

Time Dry – may be selected for any load if Sensor Dry is not used. Press the “+” or “–” time pad to select the desired number of minutes.

Step 2

Dry Temp – there are four temperature settings. Press the up “” or down “” pads to select regular, medium, delicate or extra low temperatures.

Regular – for sturdy cottons or those labeled “Tumble Dry.”

Medium – for permanent press, synthetics, lightweight cottons or items labeled “Tumble Dry Medium.”

Delicate – for heat sensitive items labeled “Tumble Dry

Low” or “Tumble Dry Warm.”

Extra Low – provides the lowest heated dry temperature possible. “Extra Low Temperature” is lower than “Delicate.”

Step 3

Select Dryness Level – press the “ ” or “ ” arrow pads to select the desired dryness level.The dryness level can be set on or between a setting.

wrinkle prevent

Very Dry – used to completely dry sturdy or bulky items including towels and jeans.

Normal – used for drying the majority of loads.

Damp Dry – designed to partially dry items. Used for items that lay flat or hang to dry.

Step 4

Setting the Signal – the end of cycle signal is adjustable. Press the “+” or “–” signal pad to increase or decrease the volume of the signal.

5