18 CHAPTER 1: WX SWITCH OVERVIEW
Table 5 WXR100 Status LEDs LED Appearance Meaning
Power status Solid green The switch is receiving power.
Unlit The switch is not receiving power.
Link
(ports 1 and 2)
Solid green 100-Mbps link is operational.
Solid amber 10-Mbps link is operational.
Blinking green Traffic is active on the 100-Mbps link.
Blinking amber Traffic is active on the 10-Mbps link.
Fn
(port 1 only)
Solid green The switch is booting and is loading its
configuration file. This LED state lasts
for three seconds.
Blinking green The switch is booting but the Fn
switch is being pressed. The switch
does not load its configuration file but
instead contacts WX to request a
configuration.
This LED state lasts for three seconds.
Unlit The switch has finished booting.
MAP (port 2 only) Solid green For a MAP access point’s active link,
with PoE enabled, all the following are
true:
MAP access point has booted.
MAP access point has received a valid
configuration from the WX switch.
Management link with an MAP access
point is operational.
Alternating green and
amber
MAP access point is booting with an
image received from the WX switch.
If the LED remains in this state
indefinitely, the boot or configuration
attempt has failed.
Solid amber PoE is on but no MAP access point is
connected to the link.
Blinking amber MAP is not connected or is
unresponsive, or there is a PoE
problem.
Unlit Port is not configured as a MAP access
port, or PoE is off.