Installing the Desktop Stand | 3M Dynapro ET 350 Monitor and ET 3250/55 Computers |
|
|
Attaching the mounting bracket
1.Thread one of each of the remaining four lock washers through one of each of the remaining four screws.
2.Thread the screws and lock washers through the four holes on the back of the mounting bracket.
3.Position the mounting bracket so that each is aligned with a hole on the back of the unit.
4.Use the screwdriver to tighten the screws to a torque of 10
Attaching the angle bracket
Use the knob provided to attach the angle bracket to the mounting bracket. To adjust the viewing angle of the display up or down, slide the angle bracket up or down in the slot before tightening the knob.
13892 (Rev. 1.1) | Page 2 |