3M™ Mobile Projector MP225
10 © 2012 3M. All Rights Reserved.
English
Getting Started

Removing the Protective Film

When the projector is shipped, there is a protective film between the batter y and
the battery contacts on the projector. Remove the protective film by removing the
battery and the protective film, discard the film and finally install the bat tery.

Install Battery

The 3M Mobile Projector MP225 comes with a rechargeable bat tery. The battery
should be fully charged before using th e projector with the batte ry.
To install the battery: point the contacts on the battery towa rd the contacts on the
projector, insert the end farthest from the battery latch first , then push down until
the battery clicks into place.

Remove Battery

To remove the battery: slide the battery latch away from the battery and t hen lift the
battery out, starting at the end closest to the latch.
Important Note: Use only the 3M specified battery: 78-6972-0058-8.