Manual Tape Applicator MTA-2

 

Page 2

 

 

 

 

 

 

 

 

Figure 4: Adjustment of the upper tape guide rolls

Figure 5: Adjustment of the lower tape guide rolls

Figure 6: Adjustment of vertical guide plate

Figure 7: Adjustment of the pointer system

Tape Application

Determine where the first skip or long line starts by measuring from the last existing skip or reference mark. Adjust the pointer to the pre-marking. Best case is when the pre-marking and the later tape position are in between the wheels of the applicator. If primer is used apply tape exactly on primer.

For starting the application pull handgrip and watch tape being moved by infeeding-transportation roll. Position tape start at start of pre-marking. Push applicator forward and keep handle grip pulled until tape appears on other side of rubber application roll. Release handle-grip and keep pushing applicator.

Figure 8: Infeeding Handle Grip

Tape Cutting

Bring the applicator to a complete stop. Keep tape under slight tension.

Cut tape with one strong and fast movement of foot pedal. Release the pedal slowly. Do not attempt to cut the tape while moving. Cutting the tape in motion will stretch and tear the tape, causing the next line to start off center.