DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 8)
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 8
2.Fastening the unit to the factory radio mounting bracket. (Fig. 9) (Fig. 10)
Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 ⋅ 8 mm) or flush surface screws
(5 ⋅ 9 mm), depending on the shape of the screw holes in the bracket.
Fig. 9
Screw
Dashboard or Console
Factory radio mounting bracket
Fig. 10
