41-001348-00 Rev 04
6725ip Phone Quick Reference Card

Phone Requirements

Microsoft Lync Server 2010
LAN - 10/100/1000BaseT Ethernet, category 5/5E/6 straight through cabling
Power source - IEEE 802.3af Power-over-Ethernet source or the Aastra 48V Power Adapter (Optional Accessory)

Parts List

Front Panel

Back Panel

OK
Softkeys
OK/Navigation Key Incoming Call Light
Unied Communications (UC)
Presence Logo
Headset Key
Speakerphone Key
Volume Up Key
Mute Key
Back Key
Home Key
Voicemail Indicator
Keypad
Volume Down Key
OK
6725ip Phone
Documentation
Phone Handset Handset
Cord
Ethernet
Cable
Telephone Base
Desk Legs
USB Cable
Headset Jack Handset Jack
Handset Cord Channel
Leg Slot Locations
To connect to the network:
1. Connect one end of the RJ-45 Ethernet cable (supplied)
into the port marked “LAN” on the base phone.
2. Connect the other end of the Ethernet cable into your
network source jack.
For Ethernet networks that DO NOT supply
Power-over-Ethernet to the phone:
1. Connect an Aastra 48V power adapter (optional accessory)
to the power port on the base phone and plug the other end
into a wall power outlet.
PC
LAN
USB Port
Type A
Ethernet
LAN Port
48V Power Port
(connection not required if power
provided over Ethernet connection)
USB Port
Type B
Ethernet
PC Port

Setting up your phone

To connect the handset to the phone:
1. Connect one end of the handset cord (B) to the handset (A)
and the other end of the handset cord (B) to the handset jack
on the back of the phone (C).
2. Guide the cord through the channel on the back of the phone
to the outer edge (as shown in the “Back Panel” illustration).
ABC
To connect the legs to the phone:
A total of four dierent viewing angles allows you to
personalize your viewing preference.
1. Attach each leg by inserting the tabs on the leg into the slots
on the bottom of the phone. There are three pair of leg
slots on each corner of the phone (D).
2. For a higher viewing angle, use the second and third slots from the top.
3. For a lower viewing angle, use the rst and second slots from the top.
4. Push the stand towards the phone until it snaps into place.
D
(Optional) Connect the phone via USB

to your computer

To connect the phone to your computer:
1. Connect the USB Type B connector on the USB cable (supplied)
to the Type B port on the base phone (see illustrtation above).
2. Connect the USB Type A connector on the USB cable to a USB port
on your computer.
USB Type B
connector
to phone
USB Type A
connector to
computer
TM
®