Acer 1911 Interface for Arm Applications, Cable Installation, Connecting the AC Power

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-2.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-3. These specifications meet the VESA Flat

Panel Monitor Physical Mounting Interface Standard (paragraphs

2.1 and 2.1.3, version 1, dated 13 November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application. Figure 1-3

Cable Installation

Please follow these instructions to install the cables.

1. Remove the back panel n from the rear of the monitor.(See Fig. 1-4)

2. Place the signal cable, the audio cable into their correct socket.

Figure 1-4

Connecting the Display to your Computer

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor’s VGA port. (See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port on your PC.

4. Make sure connections are secure.

Figure 1-5

Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

Connecting the AC Power

1. Connect the power cord to the AC socket. (See Fig. 1-6)

2. Connect the power cord to an AC power source.

Figure 1-6

Connecting the Audio Cable

1. Connect the audio cable to the "LINE OUT " jack on your PC's audio card or to the front panel's “AUDIO OUT” jack of your CD ROM drive. (See Fig. 1-7)

2. Connect the other end of the audio cable to the LCD Monitor's "LINE IN" jack.

Figure 1-7

3