30 Chapter 1
NOTE: Please pay attention to the fellowing:
*1. The inverter can work in 7.5V input voltage (continuous), but 7.5 V el ec tron ic ch arac te ris tic w il l n ot b e c are .
(Note: the display must be normal and can not glitter or become dark.)
*2. Limited lamp maximum current by DAC_BRIC signal:
When DAC_BRIG voltage is 0V and INV_PWM enables (100%), lamp has max. current.
When DAC_BRIG voltage is 3.3V and INV_PWM enables (100%), lamp has min. current.
When add 1V DAC, the 100% Lamp current will decrease 0.5mA.
DAC_BRIG signal comes from system chipset with internal resistance of 3K
*3. Inverter operating frequency should be within specification (45~65kHz) at max. and min. brightness load.
*4. INV_PWM enable implies INV_PWM signal is High level (On duty cycle is 100%). It is a square wave of
150Hz to adjust backlight brightness that is a function of PWM duty cycle. Backlight brightness is maximum
value under INV_PWM at 100% and brightness is minimum under INV_PWM at 30%.
*5.The system interface signals belong to 3.3V.
*6. Please make sure open lamp output voltage should be within starting voltage specification.
*7. Inverter should pass human body safety test.
*8. Inverter should be no smoking by any component open/short test.
*9. Transformer voltage stress should not be over 85% under any condition.
(turn on overshoot transient and line transient.)
*10. Audio noise should be less than 36dB at 10cm distance.
.15 Turn off
voltage
(Low side)
Voff -- -- 150Vp-
PV PWM=30%
16 Voltage
Rise time
(Low side)
Trise -- -- 300us us PWM=30%
17 Voltage fall
time (Low
side)
Tfall -- -- 300us us PWM=30%
Electrical specification
No
.Symbol Min. Typ. Max. Unit Comment
1 V oper* -- 650 -- Vrms Lamp operating voltage
(650+/-50)
Il 6.2 6.5 6.8 mArms DAC_BRIG: 0V,
PWM:100%
Il 3.07 3.3 3.6 mArm s DAC _BRIG : 0V,
PWM:30%
Il 5.7 6.0 6.3 mArms DAC_BRIG: 0V,
PWM:100%
Il 2.7 3.0 3.3 mArms DAC_BRIG: 0V,
PWM:30%
F 455565kHz
η80% -- -- --
Electrical Characteristics
No
.Parameter Symbol Min. Typ. Max. Unit Comment
Ω