Chapter 1 - Getting Started 1-17
1.7.3 Correcting Error Conditions
As a general rule, the "Press F1 to continue" error message is caused by a
configuration problem which can be easily corrected. An equipment malfunction
is more likely to cause a fatal error, i.e., an error that causes complete system
failure.
Here are some corrective measures for error conditions:
1. Run Setup. You must know the correct configuration values for your system
before you enter Setup, which is why you should write these values down
when the system is correctly configured. An incorrect Setup configuration is a
major cause of power-on error messages, especially for a new system.
2. Remove the system cover according to the directions in the system housing
installation guide. Check that the system board and any expansion boards are
set correctly.
3. Check that all connectors and boards are secure. Consult the system housing
installation guide for assistance.
If you have purchased a new hard disk drive
and cannot access it, it may be because your
disk is not physically formatted. Physically
format the disk using the FDISK and
FORMAT commands.
If you follow the corrective steps above and still receive an error message, the
cause may be an equipment malfunction.
If you are sure that your configuration values are correct and your battery is in
good condition, the problem may lie in a damaged or defective chip. Contact an
authorized service center for assistance.