6-8Field Service
6.5.5 Removing/Replacing Expansion Memory
To remove and replace an expansion memory module (soDIMM), perform the following procedure:
1. Power down the notebook, disconnect the AC adapter, and any installed battery packs.
2. Disconnect any peripheral device interface cables from the external interface connectors and
remove any installed PCMCIA options.
3. Turn the notebook over and locate the Expansion Memory Access Cover on the bottom of the
notebook.
4. Remove the screw holding the Expansion Memory Access Cover and remove the cover.
5. To remove a memory module, first release the slot locks located on each side of the Expansion
Memory Connector to release the DIMM. Then pull the memory module out (refer to Figure 6-
8).
6. To replace or install a DIMM module, first align the connector edge of the memory module with
the key in the connector. Insert the edge of the memory module board into the connector using
a rocking motion to fully insert the module. Push downward on each side of the memory
module until it snaps in place.
7. Reinstall the Expansion Memory Access Cover using the screw removed in Step 4.
Figure 6-8 Memory Expansion Removal/Replacement
Note: After installing expansion memory in your notebook, you must run the PHDISK utility in order
for the Save-To-Disk or 0V Suspend functions to operate correctly (refer to the procedure
in Chapter 2 of this manual).