The following table describes the parameters found in this menu.
Parameter | Description | Options |
Init Display | Initialize the AGP video display before initializing |
|
First | any other display device on the system. Thus the |
|
| AGP display becomes the primary display. |
|
|
|
|
Reset | Normally, you leave this field Disabled. Select | [Enabled], |
Configuration | Enabled to reset Extended System Configuration | [Disabled] |
Data | Data (ESCD) when you exit Setup if you have |
|
| installed a new |
|
| reconfiguration has caused such a serious conflict |
|
| that the operating system cannot boot |
|
|
|
|
Resources | This item allows user to assign PnP resource (I/O | [Auto] |
Controlled By | address, IRQ&DMA channels) for Plug and Play | [Manual] |
| compatible devices automatically or manually |
|
|
|
|
IRQ Resources | When resource are controlled by manually, assign | [Press Enter] |
| each system interrupt a type , depending on the type |
|
| of device using the interrupt. |
|
| Option: |
|
| [PCI Device]: Assign this IRQ for PCI device. |
|
| [Reserved]: Reserve this IRQ for other device. |
|
|
|
|
PCI/VGA | This option is only very rarely needed. It should be | [Disabled], |
Palette Snoop | left at “Disabled” unless a video device specifically | [Enabled] |
| requires the setting enabled upon installation. |
|
|
|
|
Maximum | This field displays maximum payload size of the | |
Payload Size | system |
|
|
|
|
PCI 1/2 IRQ | This item allows user to assign PCI IRQ for device | [Auto], [3] , |
Assignment |
| [4] , [5] , [6] , |
|
| [7], [10] , |
|
| [11] , [12] , |
|
| [14] , [15] |
|
|
|
47
