Acer TCO99 installation instructions Operating Your Monitor, OSD Options

(1)	Power Cord	Attach the monitor to the power cord which should then be
		inserted into a properly grounded electric socket.
(2)	DVI Cable	Connect the signal cable to the DVI output socket of the graphics card
	(option)	on the computer. Then tighten the thumbscrews on the connector
(3)	VGA Cable	Connect the signal cable to the VGA output socket of the graphics card
		on the computer. Then tighten the thumbscrews on the connector

WARNING: The D-Sub 15 pin plug of the VGA cable is trapezoid in shape. Make sure the shape of the plug matches the shape of the socket it is inserted into, and that none of the pins are bent or otherwise damaged.

Operating Your Monitor

First, switch the power on to the monitor, then switch the power on to the computer. When you see the LED on the power button go green, this indicates the computer is ready for use. Allow about 10 seconds for the video signal to appear. If you do not see the green light on the power button or a video signal, check the connections .

1AUTO

2

4MENU

If OSD is active, press to exit. If OSD is inactive, press and the monitor will automatically optimize the display position, clock and phase of your display.

If OSD is active, press to select or adjust OSD options.

If OSD is active, press to select or adjust OSD options.

Press to view OSD. Press again to exit.

Power on/off

Green: power on

Orange: in sleep mode

OSD Options

Please refer to "External Controls " on Page 5. To adjust the OSD settings :

1.Press the MENU button to open the OSD menu.

2.Use the buttons marked < or >, to highlight a control, then press the MENU button to enter

3.Use the buttons marked < or >, to adjust the control to the desired level.

4.When you have finished making all selections, press the MENU button to exit the OSD. (Or the adjustment will auto-save after 45 seconds.)