Acnodes AP4510

Paper type: GB(80kg), Paper Thickness=100 µm // Pages in book=64 // Print scale=81%

Gap (when printed at 81% scale) = Pages in book × Paper thickness / 2 = 3.200000 mm

Declaration of Conformity

“The Product complies with the requirements of the EMC Directive 89/336/EEC and the Low Voltage

Directive 73/23/EEC.”

Warning

Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

In accordance with IEC 60417, this machine uses the following symbols for the main power switch:

a means POWER ON.

b means POWER OFF.

Introduction

This manual contains detailed instructions on the operation and maintenance of this machine. To get

maximum versatility from this machine all operators should carefully read and follow the instructions in

this manual. Please keep this manual in a handy place near the machine.

Please read the Safety Information before using this machine. It contains important information related

to USER SAFETY and PREVENTING EQUIPMENT PRO BLEMS.

Power Source

Aficio AP4510: 220 - 240 V, 50/60 Hz, 8 A or more

Please be sure to connect the power cord to a power source as shown above.

Two kinds of size notation are employed in this manual. With this machine refer to the metric version.

Operator Safety:

This printer is considered a class 1 laser device, safe for office/ EDP use. The printer contains 5-milli-

wat, 760 - 800 nanometer wavelength, GaAIAs laser diodes. Direct (or indirect reflected) eye contact

with the laser beam might cause serious eye damage. Safety precautions and interlock mechanisms

have been designed to prevent any possible laser beam exposure to the operator.

The following label is attached on the back of the printer.

Laser Safety:

The optical housing unit can only be repaired in a factory or at a location with the requisite equipment.

The laser subsystem is replaceable in the field by a qualified Customer Engineer. The laser chassis is

not repairable in the field. Customer engineers are therefore directed to return all chassis and laser sub-

systems to the factory or service depot when replacement of the optical subsystem is required.

Important

Contents of this manual are subject to change without prior notice. In no event will the company be li-

able for direct, indirect, special, incidental, or consequential damages as a result of handling or oper-

ating the machine.

Caution:

Use of controls or adjustment or performance of procedures other than those specified in this manual

might result in hazardous radiation exposure.

Do not attempt any maintenance or troubleshooting other than that mentioned in this manual. This

printer contains a laser beam generator and direct exposure to laser beams can cause permanent eye

damage.

For good image quality, Ricoh recommends that you use genuine Ricoh toner.

Ricoh shall not be responsible for any damage or expense that might result from the use of parts other

than genuine Ricoh parts with your Ricoh office products.