5.2 | Attachment Clip | | |
| The ResQFix™ comes standard with an attachment clip. To |
| |
| install the clip, simply align the bottom tabs on the clip with the |
| |
| insert holes located on the bottom of the beacon. Snap the clip in |
| |
| place by pressing the top of the clip so that the two top tabs |
| |
| engage in the two insert holes on the top of the beacon (See |
| |
| figure 6). To remove the clip, push up and back on the top tabs |
| |
| one at a time to disengage from the beacon. |
| |
| The ResQFix™ clip has been designed to secure your beacon |
| |
| directly to life jacket webbing straps or belts to ensure the beacon |
| |
| is close at hand. ACR recommends that you have a strap on your |
| |
| life jacket in the shoulder area for attachment of the ResQFix™. |
| |
| The beacon should hang with the GPS receiver up in order to |
| |
| give it the best possible view of the sky. It is also recommended |
| |
| that you try your life jacket on in the water to see how you float in | | |
| it and where to best locate the beacon so that the beacon is not | ||
| in the water. You may choose to carry your beacon in a pocket |
| |
| but you should have a strap installed on your life jacket to attach |
| |
| the beacon when it is activated. This will leave your hands free | Figure 6- Attachment Clip | |
| while treading water. | ||
|
| ||
|
|
|
|
|
| NOTE: ACR recommends that once you have clipped your |
|
|
| beacon in place that you also secure the beacon with the |
|
|
| lanyard to your life jacket, backpack, etc. to ensure the unit will |
|
|
| not be lost if it should break out of the clip. |
|
|
|
|
|
5.3 | Flotation Pouch |
| |
| The ResQFix™ is a Category I beacon thanks to the neoprene flotation | ||
pouch attached to the lanyard. The pouch has been designed to work with |
|
| |
and without the attachment holster. Simply open the bottom of the pouch |
|
| |
using the Velcro and slide the top of the ResQFix™ into the pouch with the |
|
| |
GPS receiver exposed through the special cut out hole on the front |
|
| |
underneath the ACR logo. |
|
| |
The neoprene flotation pouch will accommodate the ResQFix™ and the | Figure 7 - Flotation Pouch | ||
attachment clip. The neoprene pouch is designed to float the beacon if it is | |||
|
| ||
dropped in the water. |
|
| |
|
|
| |
CAUTION: If you secure additional objects to the neoprene pouch it may sink. |
|
| |
|
| ||
|
| ||
WARNING: The ResQFix™ must be removed from its pouch when used in an emergency. |
| ||
|
|
| |
SECTION 6 – CARE AND MAINTENANCE
6.1Routine Maintenance
Carefully inspect the beacon case for any visible cracks. Cracks may admit moisture, which could falsely activate the beacon or otherwise cause a malfunction. Any cracking observed should be immediately referred to ACR for evaluation by calling
After checking the beacon case for cracks, it may be wiped down with a clean, damp cloth. Do not use any type of cleaner on your beacon.
10 | |
|
