Day Setting
∙Set hour wheel (center wheel) to 4 (4 AM) by moving the hour wheel toward the front of the unit and align 4 to Red Notch (Figure 2)
∙Take a test print to check the day printed
∙Adjust the day wheel by moving wheel toward the front of the unit
∙Take a test print to confirm correct day is printing
(Figure 2)
Hour Setting
Note: PM Hours are denoted by an underscore (eg. 12, 5, 3)
∙Adjust hour wheel by moving the center wheel toward the front of the unit
∙Align the correct hour with the Red Notch
Minute Setting
∙Hold down the minute lever (Figure 1)
∙Adjust the minute wheel to One Minute Before the current time by moving the wheel toward the front of the unit and aligning the Red Notch
∙Release the minute lever
∙The correct minute should now line up with the Red Notch
Completion
∙Take test print and verify correct time
∙Confirm ribbon is properly seated as shown in (Figure 3)
∙Plug in PD100
∙Replace cover
3
