Acu-Rite 00277DIX Troubleshooting, Care & Maintenance, Check Probe, Problem Solution

Warning Messages

When display reads “LO BAT”, replace batteries.

Check Probe

“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:

Diagnostic	Problem	Solution
Code
No	Probe cord is not connected	Verify cord connection is secure
	to the thermometer.	or reconnect cord.
	Probe cord is not functioning	Check the wire and connection
	properly. Cord may have
SC		for damage or excessive heat.
	been damaged or exposed to
	extreme heat.	Replace cord.

Troubleshooting

Problem	Possible Solution
Inaccurate	• Use standard alkaline batteries. Do
	not use heavy duty or rechargeable
temperature
	batteries.
Check Probe	• Review Warning Messages (page 7)
Display screen	• Check that the batteries are installed
	correctly. Batteries may need to be
not working
	replaced.

If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877) 221-1252 for assistance.

Care & Maintenance

Store in a dry location at room temperature. Clean thermometer with a soft, damp cloth. Temperature probe should be wiped clean with warm water immediately after direct contact with foods.

DO NOT place display unit on or near hot surfaces. DO NOT heat beyond thermometer’s temperature capacity. DO NOT use in oven. DO NOT wash in dishwasher. DO NOT immerse in water or use caustic cleaners or abrasives. DO NOT allow any part of the temperature probe or probe wire to come into direct contact with flames or flare-ups. DO NOT bend or crimp the temperature probe cord. DO NOT lift or move the thermometer by the temperature probe wire connection.

7