Acu-Rite 424, 522 Using the Thermometer High/Low Records, Troubleshooting, Operation, reception

OPERATION

Using the Thermometer

High/Low Records

The ““ and ““ records are reset every 24 hours. The time records are cleared is determined by the time the unit was powered on. For example, if unit was powered on at 6:00 pm, then high/low records reset at 6:00 pm daily.

Troubleshooting

If the wireless signal indicator shows no bars:

•Relocate the display unit and/or the outdoor sensor.

The units must be within 165 ft (50 m) of each other.

•Make sure both units are placed at least 3 feet (.9 m)

No outdoor sensor away from electronics that may interfere with the

		reception			wireless communication (such as TVs, microwaves,
				no bars	computers, etc).
					• Use standard alkaline batteries (or lithium batteries in
					sensor when temperature is below -4ºF/-20ºC). Do not
					use heavy duty or rechargeable batteries. NOTE: It
					may take up to 20 minutes for display unit and sensor
					to synchronize after batteries are replaced.
					Flashing of the outdoor temperature is generally an
			Outdoor		indication of wireless interference.
					1. Bring both the sensor and display unit indoors and
temperature					remove at least one battery from each.
is flashing or					2. Reinstall the battery in the outdoor sensor.
showing dashes					3. Reinstall the battery in the display unit.
					4. Let the units sit within a couple feet of each other
					for about 20 minutes to gain a strong connection.
	Inaccurate				• Make sure both the display unit and sensor are
					placed out of direct sunlight and away from any heat
temperature
					sources or vents (see page 5).
Display screen					• Check that the batteries are installed correctly.
not working					Batteries may need to be replaced.

If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877) 221-1252 for assistance.

6