
TROUBLESHOOTING:
The main unit may display
A. The batteries may be low, replace and repeat setup procedure.
B. The sensor may be placed outside of the effective transmission range (100 feet). C. The sensor may have outside interference that is preventing transmission.
( metal surfaces, other electronic devices, etc.). The sensor may need to be moved to another location if interference continues.
Do not return product to retail store.
For Technical Assistance and product return information, please call Chaney Instrument Co. direct at:
Battery Installation and Setup:
For installation, insert batteries in the main unit first, then install batteries in the remote sensor unit second.
To install batteries in the remote sensor unit, refer to figure 1 on page 1 for visual reference. Gently open the case along the seam separating the front and back halves. Insert two “AAA” (1.5v) batteries according to the diagram in the battery compartment.
Next, select a channel to use with the channel selection switch. You may use up to 3 remote sensors with the 00592W and the 00593W main units. Your new RF remote sensor is built with random security code technology. The main unit will learn the random security code of the remote sensor and will be registered without being interfered with by a neighbor who may be using the same type of sensor under the same channel setting.
Press the “TX” button located above the battery compartment to send a signal to the main unit. The main unit will then receive the signal from the remote sensor and log the random signal code in as the same channel you selected on the remote sensor.
To link additional wireless remote sensor units to the main unit, repeat the above steps
Fahrenheit or Celsius Setup:
To select between Fahrenheit or Celsius temperature display on the remote sensor display, push the “C/F” button located inside the case above the battery compartment.
Mode Selection:
The mode button allows you to select between different display modes on the remote sensors ) to signify that you are in the alternating display mode. If you press the “MODE” button a fourth time, you will return back to the default temperature display mode.
CLOSE THE CASE BY PRESSING THE FRONT AND BACK TOGETHER FIRMLY.
Replacing Batteries:
When replacing batteries in the remote sensor unit, the channel logged in the main unit must be cleared. Follow the appropriate main unit instructions on channel selection.
To reset the entire unit, remove the batteries in the main unit and the remote sensor(s) and the registered channel(s) will be erased. Follow the thermometer
00984 Wireless Thermometer & Hygrometer
Remote Sensor
Fig. 1
1 86.F
5
THERMO HYGRO
To access the battery compartment and the function buttons, open the case along the seam.
FRONT
BACK
The remote sensor is designed to stand or hang. For wall mounting, use the enclosed screw to mount to the desired surface. Use the slot on the back of the case to mount the remote sensor to the surface.
Remote Sensor Features:
•The remote sensor can transmit up to 100 feet
•The remote sensor has a weather resistant case. Keep the unit out of direct sunlight and direct weather conditions. This will extend the life of the unit.
•The remote sensor has a temperature measurement range of
NOTE: Severe cold weather can cause alkaline batteries to freeze and stop functioning properly. Lithium batteries are required for temperatures below
1
CHANNEL
TX C/F MODE 1 2 3
AAA 1.5v
AAA 1.5v
BACK (inside the case)
Additional Remote Sensor Placement Suggestions:
Additional sensors can be purchased separately,
•Outside your home or place of business
•Wine cellars
•In the garage
•Childrens room
•Gardens or greenhouses
•Any location that remote temperature readings are beneficial
To order more sensors by phone, please call
2 | 3 |