Sun-Heat Standard System Features
GAS BURNER
•Burner and controls CSA listed for United States and Canada
•Hot Surface ignition and electronic safety – No Pilot
•60,000, 80,000, 100,000, 125,000, 150,000, 175,000, 200,000 Btu/hr input sizes (natural or propane gas)
•Combustion Air inlet collar
•Sight glass for monitoring burner operation
•Combustion air proving differential switch
•Electrical & gas controls separated from combustion air stream
•Burner Housing 18 GA. galvanized steel
•Electrical – 120 volt/60/1 ph
•CSA listed for Vented or Unvented applications
•(1) year limited warranty
FLARED PIPE FORMS
No Clamps or Draw Bands
TUBE SYSTEM
•Combustion chamber
•Heat exchanger – as required, remaining system comes in 10' or 5' 16 gauge aluminized steel
•Flared fitting pipe connector with draw bolts at each joint
for solid compression type fitting – no gaskets or draw bands
•20' to 70' systems – Straight systems or optional “L” or “U” shaped systems using 90 deg elbows. (see schedule for tube lengths available)
•10 year limited warranty
REFLECTORS
•High polished parabolic reflectors standard
•8' or 4' lengths
•Reflector shield and tube system supported by heavy gauge wire hangers placed approx. 7' apart
OPTIONAL FEATURES
•Outside combustion air inlet hood with flexible 4" diameter duct
•90 deg elbows for “L” or “U” shaped configurations
•Diffuser “V” reflector for low mounting applications
•Vent cap adapter (4" dia steel to 4" dia class “B” vent pipe
•Line voltage thermostat
•24 volt relay to convert line voltage thermostat to
24 volt thermostat
•Burner “ON” running light