Adaptec 29320A 2, 3, 4

2Connect the other end of the cable to a SCSI connector on the

back of an external device. If you are installing only one

external device, terminate the device and skip to Step 4.

3Connect the other external SCSI devices by linking each device

to the previous one, as shown below. Terminate only the device

at the end of the chain.

4Connect power cables to all external device(s) and to the

computer.

SCSI terminator

ASC-29320A IG.fm Page 9 Tuesday, July 29, 2003 3:30 PM

Contents

Main Introduction Installing the Adaptec SCSI Card 29320A 1 2 3 4 Setting Up SCSI Devices Check the SCSI IDs Terminate the Ends Connecting SCSI Devices Connecting Internal Ultra320/160 and Ultra2 Devices 1 2 3 4 Page Page 2 3 4 More Information About Termination Troubleshooting Adaptec SCSI Card Driver Software Preloaded Adaptec Drivers Embedded Adaptec Drivers 12 Regulatory Compliance Statements Federal Communications Commission Radio Frequency Interference Statem ent European Union Compliance Statement Australian/New Zealand Compliance Statement Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035 USA