3Remove the tower’s front bezel, as shown below, saving the screws for use in Step 5.

Step 3

Step 4

4Turn the enclosure 90° so that the right hand rack mount ear and LEDs are on top, then slide the Storage Enclosure into the tower skin, as shown above.

5Replace the front bezel, using the screws removed in Step 3.

6Install the tower labels at the top and bottom of the tower. Align the holes in the top label with the LEDs on the enclosure.

7Replace the drive carriers and APCs, if necessary.

The tower assembly installation is complete. Continue with Step 2: Installing the Drive Carriers, below.

Step 2: Installing the Drive Carriers

These instructions assume that the drive carriers have already been attached to your disk drives.

!Caution: Acclimate new disk drives to room temperature before you install them and power up the Storage Enclosure.

To install the drive carriers into the Storage Enclosure:

1Hold the drive carrier with the LEDs on the left side (at the bottom for tower-mounted systems) and select an open disk drive slot.

Note: It is easiest to install the drive carriers from left to right on the Storage Enclosure.

6