ADCP-50-304 • Issue 19 • June 1999 • Section 6: Installation
AUTO SW B
AUTO SW A
INTLK V
STORE
1568-A
Figure 6-5. Autofallback Jumpers
3 CONTROL MODULE REMOTE CONTROL JUMPER INSTALLATION
The CM is factory set to configure the 9-pin D-subminiature connector as an RS-422 serial port. When the dc pulse control bank switching option is selected, the 2 × 8 jumper block must be installed on the dc pulse control side of the 3 × 8 jumper selections. Refer to Figure 6-6for illustration of the Remote Control Jumpers.
Caution: Incorrect strapping of remote control jumpers may result in damage to components and/or inadvertent switching.
DC PULSE
CONTROL
RS-422 SERIAL | 1561-A |
|
CONTROL | |
Figure 6-6. Remote Control Jumpers
Page 6-7
© 1999, ADC Telecommunications, Inc.
