Adcom ACE-615 owner manual Operation, Front Panel Control, Remote 12v Trigger Control

Operation

The unswitched front panel LED e indicates that AC current is passing through the ACE-615 and into the components connected to the unswitched AC rear panel outlets 1). The unswitched LED e is always on provided the unit is plugged into an active AC source.

To prevent turn-on thump, the jacks for the accessories and amplifiers have seperate relays. When the ACE-615 is turned on, the accessories power up before the amplifiers. When powering down, the relay works in reverse. These delays are in effect both with the 12V trigger source, and without, and the duration may be adjusted by your autho- rized ADCOM dealer.

Front Panel Control

Press the ACE-615 power button b to activate the unit. The power LED b, accessories LED c, and amplifiers LED d will glow red. AC power is being supplied to all connected components.

Remote 12v Trigger Control

*Note: This section only applies when an external trigger is connected to the 12v trigger in jack 1@.

*Note: The unit only responds to an external trigger when the power button b is pressed in. The power button b can be used to override the 12v trigger input and turn the ACE-615 off.

Press the ACE-615 power button b to put the unit into standby mode. The power LED b will glow amber

indicating it is waiting for an external 12v trigger to power on. Turn on the component supplying the 12v trigger. The ACE-615 power button LED b and switched LED c and amplifiers LED d will glow red indicating AC power is being supplied to all connected components. Turn off the 12v trigger supply to return the ACE-615 to standby mode.

Typical Connections

to device

from wall

	coax 1		coax 2		Surge Protector and AC Enhancer model ACE-615	12v trigger
					voltage: 120V AC/60Hz, internal power consumption: 10w max
			max 300W		max 1500W
out	in	out	in	unswitched	amplifiers (switched 10 sec delay on turn-on)
			accessories (switched 30 sec delay on turn-off)			in

out	in
phone 1	GND

to preamp

circuit breaker

		B
	T R
	I		E
U				A
C					E
R				K
					R
I
C						T
R
P						E
E
S					S
		TO		E
	S
		R
		15A

phone 2

to device

	WARNING:	For indoor use in dry	locations only.
	To reduce the risk of shock, do not expose this unit
	to rain or moisture.
from wall		television	laser disc
			player

serial	#	WARNING:	Equipment with high-current	requirements, such as hobby	arc-welders, hair
		dryers and	heaters must not be plugged into these AC receptacles. Never		allow total power
		consumption	of all equipment connected to these outlets to exceed 1800		watts.
	compact disc		DVD player	preamp	vcr
	player

	10 Timber	Lane
	Marlboro,	NJ 07746 USA	power	120v	60Hz
	Made in the USA		max	1800W
amplifier two		amplifier one			to AC outlet