Addonics Technologies manual Cable Connections Model RCMR256I, Model RCMR256SC

Step 5 Mount the board to the bottom cover.

Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the bottom cover.

Step 7 Lower the front of the top cover and making sure the two covers lined up properly. Tighten the small retaining screw on the front of the bottom cover to close the enclosure.

Cable Connections

Model: RCMR256I

Mounting holes for 3 ½” drive bay

Step 1: Connect the 40-pin IDE ribbon cable that is connected to the IDE controller on the motherboard to the 40-pin IDE connector attached at the back of the Ruby Cipher drive cradle. This is the data connection for the device.

Step 2: Connect a 4-pin floppy power cable from your system’s power supply to the 4-pin floppy power connector on the IDE bridge attached at the back of the Ruby Cipher drive cradle. This power connection provides power to the ruby cipher mobile rack.

Step 3: Slide the Ruby enclosure inside the cradle. Insert the Cipher key. To turn ON the drive enclosure, place switch on INT position. Observe that the green LED on the front of the enclosure lights up.

Note: If the LED on the front of the Ruby Cipher enclosure lights up as red color, turn of the system and reseat the cipher key. The LED must turn on as green color indicating it is setup correctly.

Model: RCMR256SC

Mounting holes for 3 ½” drive bay

Step 1: Connect the 68-pin SCSI ribbon cable that is connected to a SCSI controller to the 68-pin SCSI connector attached at the back of the Ruby Cipher drive cradle. This is the data connection for the device.

Step 2: Connect a 4-pin floppy power cable from your system’s power supply to the 4-pin floppy power connector on the SCSI bridge attached at the back of the Ruby Cipher drive cradle. This power connection provides power to the ruby cipher mobile rack.