Tower with USIB connector
connection via the Addonics USIB interface board and USIB interface cable.
• IDE and ATAPI drives must be set as Master device. USIB back panel
Inside of the USIB back panel
IDE Device Installation to the USIB Connector
The USIB setup can do hot swap when Addonics mobile racks are used
USIB board is connected to the power input from the cradle. The power to
the Addonics cradle can only go one way.
the USIB connector.
to the USIB connector.
powered down and restarted to swap out hard drive without rebooting the
system when using USB or Firewire interface.
the USIB cable must be detach from the back of the Storage Tower or the
Storage Tower power must be power off to un-mount the drive from the
computer. The drive will not be hot swappable by turning the switch on and
off from the front of the mobile rack.
IDE ribbon cable
IDE drive
USIB connector