configuration setup using PIN configuration method or PBC configuration method through an internal or external Registrar.
Pin Input Config (PIN): Start to add to Registrar using PIN configuration method. IF STA Registrar, remember that enter PIN Code read from you Enrollee before starting PIN.
Push Button Config (PBC ): Start to add to AP using PBC configuration method.
4. Soft-AP Function
Except becoming a wireless client of other wireless access points, this USB Wireless LAN utility can acts as a wireless service provider. You can switch the operating mode to “Access Point” mode to simulate the function of a real wireless access point by software, and all other computers and wireless devices can connect to your computer wirelessly, even share the internet connection you have.
To the Wireless LAN USB Adapter to bridge your wired and wireless network, the following requirements must be met：
1.The Wireless LAN USB Adapter must be installed on a computer connected to the wired network.
2.Either configure network sharing (refer to the appendix for an example) or bridge the two interfaces (wireless and wired) on the computer.
3.Set the wireless station’s IP address to be in the same subnet as the computer in which the Wireless LAN USB Adapter is installed.
4.1 Swith to AP Mode
Select “Access Point” from Mode(M) tab to make the Wireless LAN USB adapter act as a wireless AP.
After you select “Access Point” mode, the Wireless LAN USB adapter available options will change.
17
