AEG 1400 D installation instructions Introduction, Extractor version, Filter Version

Models: 1400 D

1 15
Download 15 pages 37.32 Kb
Page 4
Image 4
Introduction

Introduction

Extractor version

The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory).

You will need original AEG charcoal filter for this function (see Special Accessories).

The unit features two outlet holes, one of which A is located on the top of the unit while the other B is located on the rear.

To connect up the hose, you should first fit the bayonet-mounting flange C (Ø 120 mm) on the outlet required (if using the top outlet, fix the flange in place using the screw supplied as shown in Fig. 1). Close off the unused hole using the bayonet fitting caps D.

Warning! If is decided to use the rear outlet hole B, first remove the sponge E that closes that hole. Fig. 2.

Fig. 1

Fig. 2

Filter Version

• The air is filtered and recirculated

 

through the front grid.

 

• Move the lever G to position F -

 

Fig. 3.

 

• You will need an original AEG

 

KF14 charcoal filter for the filtering

 

function. (See Special

 

Accessories).

Fig. 3

45

Page 4
Image 4
AEG 1400 D installation instructions Introduction, Extractor version, Filter Version