Installation and Connection Instructions
| Leak Prevention System |
| For protection from damage due to water leaks, the dishwasher is |
| equipped with a leak prevention system. |
| In the event of a fault, the safety valve in the water inlet hose immedi- |
| ately interrupts the supply of water to the appliance and the drain |
| pump is activated. The remaining water in the appliance is automati- |
| cally pumped out. |
1 | The leak prevention system also works when the appliance is switched |
| off. |
Electrical connection | |
1 | In compliance with electric company technical requirements for mains |
| connections, |
by approved
When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.
Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a
Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.
To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.
If the appliance is
34
