User’s instructions
10.3.5. Water inlet
Please install the water inlet hose onto the back of your washing machine :
- Insert the seal in the hole at the bottom of the back panel (fig. 1).
- Screw on the bottom fitting of the water inlet hose as shown in fig. 2 and fig. 3.
- Connect the feed hose connector onto the water inlet tap, taking care to position the gasket correctly.
- Turn on the water inlet tap.
The water inlet hose cannot be extended. If it is too short, please contact the After Sales Department.
10.3.6. Drain
- Assemble the hose holder onto the drain hose.
- Place the assembly in a drainage pipe (or in a sink) at a height between 70 and 100 cm. Make sure that it will not fall out.
You must provide an air intake at the end of the drainage hose, to avoid any water being siphoned.
Important: the drainage hose must not be extended, on any account. If it is too short, contact a qualified engineer.
10.3.7. Electrical connection
You can only connect this washing machine to 230 V single phase power supply.
Check rating of the fuse line: 10 A at 230V.
The washing machine must not be connected through an extension cable or a power bar. Check that the earthing connection is conform with the regulations in force.
30
