AEG 40850 manual What to do if, Remedying small malfunctions

What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display dur- ing operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Abort the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code.

Malfunction	Possible cause	Remedy
	Water tap is blocked with	Check the water tap and
	limescale or faulty.	have it repaired if necessary.
	The tap is turned off.	Turn the tap on.
The cycle indicator for the	The filter (where present) in	Clean the filter in the
	the threaded hose fitting	threaded hose fitting.
selected dishwashing cycle	on the tap is blocked.
is flashing:		Cancel the dishwashing cy-
fault code Å 10 is dis-
		cle (see chapter: Starting a
played in the multi-dis-	Filters in the base of the
		dishwashing cycle),
play:
	dishwasher compartment	clean filters (see chapter:
(Problems with water in-
	are blocked.	Cleaning the filters),
let)
		then start the dishwashing
		cycle again.
	Water inlet hose	Check the position of the
	has not been correctly posi-
	tioned.	hose.
The cycle indicator for the	The sink spigot connection	Clean the sink spigot outlet.
selected dishwashing cycle	is blocked.
is flashing,
fault code Å 20 is dis-	Water drain hose
played in the multi-dis-		Check the position of the
play.	has not been correctly posi-
(Problems with water	tioned.	hose.
drainage)

28