AEG C 8 18 43-4I Installation, Remove Transport Packaging, Disposal of Old Appliances

Models: C 8 18 43-4I

1 12
Download 12 pages 10.87 Kb
Page 6
Image 6
Disposal of Old Appliances

Disposal of Old Appliances

For environmental reasons, refrigeration appliances must be disposed of properly. This applies to your old appliance, and - at the end of its service life - to your new appliance as well.

Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside.

• Use an authorised disposal site.

Contact your Local Council or Environmental Health Office to see if there are facilities in your area to recycle the appliance.

The symbol Installation on the product or on its packaging indicates that this pro- duct may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electro- nic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and

Installation

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety measures not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left and can be viewed when the salad boxes are removed.

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.

human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Remove Transport Packaging

The appliance and the interior fittings are protected for transport.

Remove all adhesive tape and packing pieces from the interior of the appliance.

Important!

The wires in the mains lead are coloured in accordance with the fol- lowing code:

Green and Yellow Earth

BlueNeutral

BrownLive

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured mark- ings identifying the terminals in your

GREEN & YELLOW

13 AMP. FUSE

 

13 AMP

 

BROWN

 

BLUE

D207

CORD CLAMP

 

Shelf holders

Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transporta- tion.

To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.

A

B

plug, proceed as follows:

1.The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth symbol or coloured green and yel- low.

2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.

3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.

4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

Warning! A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safely.

6

19

Page 6
Image 6
AEG C 8 18 43-4I Installation, Remove Transport Packaging, Disposal of Old Appliances, Electrical Connection