Installation - Fig. 6-7-8
Expansion plugs are provided to secure the hood to most types of ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of ceiling. The ceiling must be strong enough to take the weight of the hood.
During electrical connection ensure the power supply is disconnected at the domestic main switch.
•Adjust extension of the hood support structure, as the final height of the hood depends on this, and remember that with installation completed the hood must be at least 60 cm above the
•Fix the two sections of the structure using 8 screws (2).
•Place the ceiling hole diagram directly above the
•Drill as shown (6 holes for 6 wall plugs – 4 plugs for fixture), screw the outer screws leaving a space of about 1 cm. between the screw head and the ceiling (4).
•Fit an exhaust pipe inside the truss (5) and connect it to the motor compartment connection ring (exhaust pipe and fixing brackets are not supplied).
•Hook the frame onto the 4 screws (6 - see also step 4). CAUTION! The side of the truss with connection box corresponds to the side of the control panel with hood assembled.
•Tighten the 4 screws (7).
•Insert and tighten another 2 screws in the remaining free holes (8) for secure fixing.
•Carry out the electrical connection (9) to the mains power supply, only turn on the power supply upon completion of assembly.
•Hook the hood onto the truss (10) , ensuring it fits properly – to hook the hood onto the truss partially tighten 4 screws (see also step 12).
•Secure the hood to the truss using two screws (11); this will also help center the two sections.
•Tighten the 4 screws securing the truss to the hood (12).
•For extractor versions (13A), connect the other end of the exhaust pipe to the flue.
For filter versions (13F), fit deflector F to the truss and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector.
89
