Wall mounting - Fig. 8
•Mark a centre line on the wall (1).
•Fix the drilling template to the wall (2).
•Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired at lower points.
•Insert the three Ø 8mm expansion plugs into the wall (4).
•Insert 2 5x45 screws (5) but do not tighten them completely, hang the hood (6).
•Only DU 4161 - DU 4361 - DU 4561: Adjust the unit so that it is positioned at a right angle to the wall by turning the two screws on lower side (7).
•Tighten the 2 upper screws (8).
•From inside the hood, insert the third 5x45 screw into the lower hole
(9) and tighten (10).
1
| 3 | 5! | 6 |
|
| |
|
|
|
|
| ||
3 | 4 |
| 7 | 9 | 8 | |
5 | 6 | |||||
| ||||||
4 | 4 |
| 8 |
| 10 | |
| 5 | 7 |
|
| ||
|
|
|
|
2
Fig. 8
80
