AEG HK654200IB user manual To attach the seal to the rabbet

6Installation instructions

WARNING!

Risk of injury from electrical current. Carefully obey the instructions for electrical connec- tions.

•The electrical mains terminal is live.

•Make electrical mains terminal free of voltage.

•Install correctly to give shock protection.

•Loose and incorrect plug and socket connections can make the terminal become too hot.

•A qualified electrician must install the connections in the clamps correctly.

•Use a strain relief clamp on cable.

•Use the correct mains cable of type H05BB-F Tmax 90°C (or higher) for a single phase or two phase connection.

•Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or

higher). Speak to your local Service Centre.

The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.

You must have correct devices to isolate: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors.

To attach the seal to the rabbet

•Clean the rabbet in the work surface.

•Bond the seal stripe supplied on the upper surface of the rabbet along the edges of the cut out section.

•Cut the seal stripe into four pieces in relation to the length of the edges of the rabbet.

•For the four corners of the rabbet the ends of the seal stripes must be cut into mitres. Do not bond the ends over one another.

•Bond the seal stripe flush into the corner of the rabbet. Make sure that no silicon com- pound can get below the glass ceramic when grouting.

•Do not extend the tapes.

Assembly

	min.
	500mm
min.	min.
50mm	50mm
	min.
	5mm