AEG W 1230 manual Feet are not correctly set Tion and connection

		Operating Instructions
Problem	Possible Cause	Remedy
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
	The height-adjustable screw	Adjust the feet according to
		the instructions for installa-
	feet are not correctly set.
		tion and connection.
The washing machine	There is very little washing in	This does not impair the
vibrates during opera-
tion or wobbles.	the drum (e.g. only one	function.
	dressing gown).
	The water could not be com-	Check along the drain hose
		and remove any kinks
	pletely pumped out before	present, or clean the drain
	spinning because
		pump and, if necessary, re-
	the drain hose is bent or
		move foreign bodies from
	the drain pump is blocked.
		the pump housing.
	The screw connection on the	Tighten the inlet hose screw
	inlet hose is leaky.	connection.
	The drain hose leaks.	Check the drain hose and re-
		place it if necessary.
	The drain pump cover is not	Close cover correctly.
	correctly closed.
Water runs out under		Interrupt the programme
		and remove washing from
the washing machine.	Washing is stuck in the door.
		the door. Start the pro-
		gramme again.
		Seal the emergency drain
		hose correctly (see section
	Emergency drain hose is not	“Carrying out an Emergency
	correctly sealed or is leaking.	Emptying Operation“). If the
		emergency drain hose leaks
		contact customer service.
	RINSE HOLD has been se-	Cancel RINSE HOLD.
The washing machine	lected.
does not spin; there is	Soaking programme has fin-	Release SOAKING button
water in the drum.
		(main wash programme will
	ished.
		follow).

31