Aegis Micro 12820 manual Problem, Possible cause Solution

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

Possible cause	Solution
The water tap is closed (E10).	Open the water tap.
The water inlet hose is	Check the whole length of the
squashed or kinked (E10).	hose and remove the kink.
The small filter of the water	Clean the filter.
inlet hose is clogged (E10).
The door is not properly	Close the door.
closed (E40).
The end of the drain hose	Place the hose at the right
is too low.	height (see Installation
	section).
The drain hose is	Check the whole length of
squashed or kinked (E20).	the hose and remove the
	kink.
The drain pump or the	Clean the pump or check
drain hose are clogged (E20). the hose.
The RINSE HOLD option	Empty out the water by
(stop with water in	pressing the START button
drum) has been selected.	or selecting the DRAIN
	programme.
The laundry is not evenly	Redistribute the laundry
distributed inside the drum.	manually in the drum.
Too much detergent has	Measure detergent
been used.	according to the
	manufacturer’s instructions.
An unsuitable detergent	Use a suitable washing
has been used that	machine detergent.
creates too much foam.
One of the connectors on	Check that the hose is
the water inlet hose is	firmly screwed on at both
leaking.	ends.
The drain pump has not	Fully screw the pump into
been properly screwed on	place.
after cleaning.
The cap on the emergency	Replace the cap on the
emptying hose has not been	emergency emptying hose
replaced after cleaning the	after cleaning the pump.
pump.

38