Aero Mist 52469 Tools Required, List Of All Enclosed Parts, High-Pressurepump, Brass End Plug

TOOLS REQUIRED

Tape Measure

PVC Tubing Cutter

5/8" Open-End Wrench

9/16" Open-End Wrench

LIST OF ALL ENCLOSED PARTS

QTY PART NO DESCRIPTION

156401 Flexible Nylon Tubing 50 ft Roll

552468 3-Nozzle Fog Riser (pre-assembled)

1552411 .012 Misting Nozzle - Fine

152513 Brass End Plug

HIGH-PRESSURE PUMP

For optimum performance of your new Aeromist 15-Nozzle Fog Kit (52469) we recommend the use of an optional 1000 PSI high- pressure pump to create fog. This system is expandable with up to 30 (.012 size) nozzles using our 1000 PSI Misting Pump (60100K). Larger pumps are also available. Please see the en- closed accessories brochure or visit www.aeromist.com for other available pumps, upgrades and accessories.

INSTALLATION INSTRUCTIONS

1.Connect Flexible Nylon Tubing (56401) to outlet of high-pressure pump.

2.Bury tubing approximately 6" underground. Cut Flexible Nylon Tubing (56401) with a PVC Tubing Cutter. Insert tubing into brass tee of the 3-Nozzle Fog Riser (52468) until it bottoms out in the fitting. Complete seal with one wrench turn of fitting. Continue by con- necting tubing from one riser to next. Space risers 2-10 feet apart as desired. Closer spacing will result in denser fog. After the last riser, attach a short piece of tubing and terminate with the Brass End Plug (52513).

3.Flush system for several minutes before inserting nozzles. Install nozzles in 3 risers nearest the pump (hand tighten only) and flush again for one minute. Install nozzles in each additional riser, one-at-a-time and flush again until nozzles in all risers are installed.

MAINTENANCE

•Nozzles require cleaning or replacement periodically. Clean nozzles by soaking in vinegar or calcium removal product overnight or replace as needed.

•Winterize your misting system by draining water out of lines. Be sure all water is drained from Fog lines. This will prevent water from freez- ing and damaging the fog line. This can be accomplished by forcing compressed air through the lines.

Warning! Fogging system is intended for outdoor use only.

•Use normal tap water or soft water only.

•Do not exceed 1000 PSI,

•Do not unscrew nozzles while under pressure

•Do not touch nozzles when system is pressurized

Brass End Plug (52513) 3-Nozzle Fog Riser (52468)

OPTIONAL ACCESSORIES

PART NO DESCRIPTION

60100K 1000 PSI Misting Pump

56401 Flexible Nylon Tubing 50 ft Roll

52468 3-Nozzle Fog Riser (pre-assembled)

52473 1-Nozzle Fog Riser (pre-assembled)

52411 .012 Misting Nozzle - Fine

52513 Brass End Plug

52510 Brass Union

52512 Brass Tee

FREQUENTLY ASKED QUESTIONS

QHow many nozzles can I use with 1000 PSI Misting Pump (60100K)?

A30 nozzles and still maintain 800-1000 PSI range

QHow much fog will this create?

AFog varies depending on temperature, humidity and spacing

QDoes this create cooling?

AYes, this creates cooling when the fog evaporates.

QCan nylon be buried under concrete? Y Yes, recommend using sleeving.

Connect to High-Pressure Pump

Soil Line