Installing Your Refrigerated Wine Cooler
Select Location
The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Best performance will be maintained when installed within the following parameters:
Ideal Ambient Temperature Range
65° | – 80°F | |
65° | – 90°F. |
A gap of 24in (606mm) is recommended between units for moving the wine chiller. A clearance of 3in (76mm) is required to the side of the unit that the hinges are located on to allow for the door to open 90° degrees. Please see diagram for recommendations for built in applications.
24”
left hand swing
24”
wall structure
adjacent cabinet
right hand swing
3“/76mm
Cabinet Clearance
Adjacent cabinets and countertop can be installed on top, back and sides of the unit as long as the grille and door access remain unobstructed. Ventilation is required for the bottom front section of the unit where the grille is located. Keep this area open and clear of any obstructions.
Make certain that the leveling legs supplied with the wine cooler are installed according to the instructions. Leveling adjustments can be made by raising or lowering the glides on the bottom of the unit.
DISCONNECT POWER SOURCE BEFORE ADJUSTING
LEVELING LEGS
Electrical Connection
Use nominal 115 volt, 60 cycle AC only. DO NOT USE AN EXTENSION CORD
Grounding Method
This product is factory equipped with a power supply cord that has a
THIS UNIT SHOULD NOT, UNDER ANY
CIRCUMSTANCES, BE UNGROUNDED.
All specifications and product design subject to change without notice. | 3 |
Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.