Additional Safety Notices
The following general safety precautions must be observed during all phases of oper- ation of this instrument. Failure to comply with these precautions or with specific warnings or instructions elsewhere in this manual violates safety standards of design, manufacture, and intended use of the instrument. Agilent Technologies assumes no liability of the customer’s failure to com- ply with the requirements.
General
Do not use this products in any manner not specified by the manufacturer. The protec- tive features of this product may be impaired if it is used in a manner not speci- fied in the operation instructions.
Before Applying Power
Verify that all safety precautions are taken. Make all connections to the unit before applying power.
Ground the Instrument
This product is provided with protective earth terminals. To minimize shock hazard, the instrument must be connected to the ac power mains through a grounded power cable, with the ground wire firmly con- nected to an electrical ground (safety ground) at the power outlet. Any interrup- tion of the protective (grounding) conduc- tor or disconnection of the protective earth terminal will cause a potential shock haz- ard that could result in personal injury.
Do Not Modify the Instrument
Do not install substitute parts or perform any unauthorized modification to the prod- uct. Return the product to an Agilent Sales and Service Office for service and repair to ensure that safety features are maintained.
In Case of Damage
Instruments that appear damaged or defec- tive should be made inoperative and secured against unintended operation until they can be repaired by qualified service personnel.
Safety Symbols
Alternating current
Frame or chassis terminal
Standby supply. Unit is not completely disconnected from ac mains when switch is off
Caution, risk of electric shock
Caution, refer to accompanying description
Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC
This product complies with the WEEE Directive (2002/96/EC) marking require- ment. The affixed product label (see above) indicates that you must not discard this
electrical/electronic product in domestic household waste.
Product Category: With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a “Monitoring and Control instrumentation” product.
To return unwanted products, contact your local Agilent office, or go to www.agilent.com/environment/product for more information.
Technical Support
If you have questions about your shipment, or if you need information about warranty, service, or technical support, contact Agilent Technologies:
In the United States: (800) 829-4444
In Europe: 31 20 547 2111
In Japan: 0120-421-345
Do Not Operate in an Explosive Atmosphere
Do not operate the instrument in the pres- ence of flammable gases or fumes.
Do Not Remove the Instrument Cover
Only qualified,
Or go to www.agilent.com/find/assist for information on contacting Agilent in your country of specific location. You can also contact your Agilent Technologies Representative.
Agilent | iii |
