Getting Started with the Agilent E1438
To use the Resource Manager | TousetheResourceManager |
| The Resource Manager is a program from your hardware interface manufacturer. It looks at the | |
| VXI mainframe to determine what modules are installed. You need to run it every time you power | |
| up. If you get the message: "VISUCCESS_DEVICE_NPRESENT" then run | |
| Manager. | |
| Before running the Agilent E1438 software make sure that your hardware is configured correctly | |
| and that the Resource Manager runs successfully. Before using your measurement system, you | |
| must set up all of its devices, including setting their addresses and local bus locations. No two | |
| devices can have the same address. Usually addresses 0 and 1 are taken by the | |
| and are not available. | |
| For more information about the Resource Manager, see the documentation with your hardware | |
| interface. | |
| Most Resource Managers will recognize the manufacturer and model number of the | |
Note | ||
Agilent E1438 but if your interface requires that you enter this information manually, use the | ||
following: | ||
Manufacturer number: 4095 (Hex FFF) | ||
Model number: 622 (Hex 26E) |
21
