Getting Started 35Chapter 1
Example: Divider with
Filter Configuration Any channel can be configured as a resistor divider with a low-pass filter
connected to the normally open contact of the Form C relay. Figure 1-22
shows a typical divider with filter configuration. For this example, resistor
R25, capacitor C25, and SIP resistor pack R24-31 are to b e added. Set one
configuration jumper as shown in Figure 1-22 (LP/DIV).
Figure 1-22. Example: Divider with Filter Configuration
TERMINAL
MODULE SWITCH
MODULE
Channel 25
R25
V24-31
C25
COM
NC
NO
C25
R25
RP
24-31
Wiring
Terminal
Module
To
User
and associated pullup voltage (for optional standup resistors)
User Supplied Resistor Packs (SIP) Locations
V8-15
V0-7
RP0-7
RP8-15
V16-23
V24-31
RP16-23
RP24-31
Channel Capacitor
Channel Resistor
Solder Holes
Solder Holes
Jumpers
Configuration
Number
Channel
Channel
COM
NO
NC
COM
NC
NO