Agilent Technologies FS4100 The Format Menu

The Format Menu The USB Analysis Probe diskette sets up the format

menu as shown in the following table. This format is

the same for both Timing and State Analysis. Pods 1

and 2 are for STATE analysis and POD 3 is useful for

Timing analysis.

Label Pod 4 Pod 3 Pod 2 Pod 1

STAT 15:11 16

ADDR 10:0

DATA 15:0 15:0

ADR 10:4

ENDPNT 3:0

PID 15:11 16

CTLCMD 15:11 16:8

MCLK 16

CLK12 16

MDATA 15

SOFTIC 14

EOP2_1 13:11

LBC3_0 10:7

RESRVD 6:4

FEOPR 3

FEOSYN 2

LSDET 1

UNUSED 0

VP 2

VM 1

RCV 0

Contents

Main Page Page How to reach us Product Warranty Limitation of warranty Assistance Introduction How to Use This Manual Page Analyzing the Universal Serial Bus Duplicating the Master Diskette Accessories Supplied Minimum Equipment Required Revisions Signal Naming Conventions The USB Analysis Probe Switches and Diodes Connecting to the USB Analysis Probe Installing the USB Analysis Probe Setting up the Analyzers installed in the 16500 mainframe. Setting up the 167xx Analyzer Setting up the 1680/90/900 Analyzer Loading 1680/90/900 configuration files Page Offline Analysis Page Page The Format Menu Page Page Page COMBINATION MODE Bad EOP Detection Low Speed/High Speed detection Page State Analysis Installation Quick Reference Acquiring Data The Page Page Timing Analysis Installation Quick Reference Acquiring Data POD 3 Description Page Page USB Analysis Probe Test Points The Waveform Display General Information Characteristics Signal Connections