NYLON
WING NUT 
5/16" FLAT
WASHER 
NYLON
WASHER
1/4" x 3/4" | ADJUSTABLE |
CARRIAGE BOLT | STOP |
FIGURE 11
20.Position the flow control mounting bracket (figure 12).
a.Push on flow control arm until it locks in "OFF" position.
b.Slide flow control mounting bracket along tube until closure plate in bottom of hopper just closes.
c.Snug the 1/4" lock nuts just enough to hold flow control mounting bracket in place.
d.Set adjustable stop at "5". Pull flow control arm against stop. Verify that closure plate has opened about half way.
e.If closure plate does not open half way, it may be closed too far at "OFF". Adjust position of flow control mounting bracket until closure plate will open about half way at "5" and still close when arm is locked in "OFF". Tighten 1/4" lock nuts.
ON
FLOW |
|
|
| |
CONTROL |
|
| ||
ARM |
|
|
| |
|
|
|
| ON |
|
|
| 2 | 1 |
|
| 3 |
| |
|
|
|
| |
|
| 4 |
|
|
| 6 | 5 |
|
|
8 | 7 |
|
|
|
9 |
|
|
|
|
10 |
|
|
|
|
FIGURE 12
OFF
OFF
AJDUSTABLE
STOP
SETTING "5"
7