TOOLS REQUIRED FOR ASSEMBLY
(1)Pliers
(1)Hammer
(2)7/16" Open or Boxed End Wrenches
1.Remove the spreader, the loose parts and the hardware package from the carton. Lay out parts and hardware and identify using the illustrations on pages 2 and 3.
2.With the spreader resting upside down on the top of the hopper, assemble a spacer and then a 5/8" flat washer onto each end of the axle. See figure 1.
AXLE
SPACER
5/8" FLAT WASHER
FIGURE 1
5.Place a wheel onto the end of the axle that has a cross hole. The long end of the hub goes to the inside. See figure 3.
6.Assemble a 5/32" x 2" cotter pin through the hole in the wheel hub and the axle. See figure 3.
7.Place a 5/8" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub. See figure 3.
5/32" x 2"
COTTER PIN
HUB CAP
CROSS
HOLE
5/8" FLAT
WASHER
FIGURE 3
3.Place a wheel onto the end of the axle that has no cross hole.The long end of the hub goes to the inside.
See figure 2.
4.Place a 5/8" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub. See figure 2.
NO CROSS HOLE
WHEEL
5/8" FLAT
WASHER
HUB CAP
FIGURE 2
4
8.Remove the nut from the middle bolt in the crossover tube. See figure 4.
CROSSOVER
TUBE
MIDDLE NUT
| SHAFT |
MIDDLE BOLT | SUPPORT |
PLATE |
FIGURE 4