9.Assemble a spacer and a
10.Place a wheel (air valve facing out) onto the axle. Secure the wheel to the axle with a 1/4" x
1/4" x | |
FLAT WASHER | |
HEX BOLT |
|
AIR VALVE | SPACER |
1/4" HEX LOCK NUT
FIGURE 4
11.Turn the spreader upright on its wheels.
12.Assemble the hitch bracket to the top of the hitch tube using two 3/8" x
13.Assemble the hitch pin through the hitch bracket and the hitch tube and secure with the hair cotter pin. See figure 5.
HITCH PIN
3/8" x
HEX BOLT
3/8" LOCK
WASHER
3/8" HEX LOCK NUT
HAIR COTTER PIN
FIGURE 5
14.Assemble the flow control link (end with small hole) to the flow control arm using a 1/4" x 3/4" hex bolt, a nylon washer and a 1/4" hex lock nut. Tighten carefully. The flow control link should not be loose but should pivot with no more than slight resistance. See figure 6.
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
1/4" x 3/4"
HEX BOLT
1/4" HEX
LOCK NUT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 6
15.Assemble the flow control arm to the flow control mounting bracket using a 1/4" x 3/4" hex bolt, two nylon washers and a 1/4" hex lock nut as shown in figure 7. Tighten carefully. The flow control arm should pivot with a slight resistance.
16.Assemble the vinyl grip. See figure 7.
VINYL GRIP
FLOW | FLOW CONTROL |
MOUNTING | |
CONTROL | BRACKET |
ARM |
|
1/4" x 3/4"
HEX BOLT
1/4" HEX
LOCK NUT
(2)NYLON WASHERS
FIGURE 7
5